HIGH CAPACITY HAND CUTTING TORCH FOR L-TEC® AND VICTOR ®STYLE NOZZLES

FEATURES - THREE TUBE DESIGN - Maximum strength, yet lightweight - USES "C" CUTTING OXYGEN AND "B" PREHEAT AND FUEL - SEPARATE CUTTING AND PREHEAT - Increases amount of preheat for quicker start - Increases amount of cutting for rapid cutting speeds - CUTS UP TO 60 INCHES OF STEEL (with 1800 series nozzles) AVAILABLE WITH 70, 90 or 180 degree head (WT-HC-60) only HC series hand cutting torch is designed for rugged, heavy duty applications in foundries, scrap yards and steel mills. It is ideal for emergency billet cutting, removes skulls and risers or any heavy hand cutting requirements. The off-set 180 degree head allows the operator to widen the cut kerf by rotating the head and deepening the cut. This torch is available with optional riding skid or an extra handle for ease of operation.

Model WT-HC-60 suitable replacement for L-Tec-63, uses L-Tec® 1808 style cutting nozzles - cuts up to 60". Model WT-HC-48 suitable replacement for Victor® HC 1500, uses Victor 2-285N style cutting nozzles - cuts up to 48". WT-1808 NOZZLE WT-1808 series nozzles are single piece solid copper nozzles. The single piece solid copper design allows for rapid heat transfer and longer, rugged life. The nozzle are chrome plated to resist corrosion, minimize slag adherence and reflect radiation heat. WT-2-285N NOZZLE WT-2-285N series nozzles are two piece solid copper shell, brass internal nozzles designed for fast starts and lower gas consumption. The shell is designed for all internals and allows for low cost replacement of the internal under most operating conditions.

 

 

The above equipment is available for delivery immediately and is F.O.B. Oakville, ON. All taxes extra, all prices listed are in Canadian funds.

Parts for the above equipment can be supplied,and we have the facilities to service and repair the listed equipment.